Hi all, I'm new to this forum and have recently purchased a solus pro from my snapon dealer which has been very helpfull apart from a few little problems.
I wanted to be able to suply a print out to customers of codes or graphs the problem is i cant seem to link the scanner to my laptop. I have even tried to link the printer directly to the scanner but only get as far as selecting the type of printer. It asks if I want to print a test page, to which i click "yes" and then it tells me no printer found!
I have also tried to code a Ford Transit injection pump. I followed all the instructions and got as far as a securety check which it said would take 30 minutes. I clicked ok... 3 hours later it was still counting so in the end i came out of the program.
Rover 75 2000 1.8 petrol - ABS lamp on but would not connect, although read engine managment no problem.
The thing is my snapon dealer isn't much help and I am now pulling my hair out.
Has anyone got any advice they could give me? Any help would be great, thanks in advance.
I wanted to be able to suply a print out to customers of codes or graphs the problem is i cant seem to link the scanner to my laptop. I have even tried to link the printer directly to the scanner but only get as far as selecting the type of printer. It asks if I want to print a test page, to which i click "yes" and then it tells me no printer found!
I have also tried to code a Ford Transit injection pump. I followed all the instructions and got as far as a securety check which it said would take 30 minutes. I clicked ok... 3 hours later it was still counting so in the end i came out of the program.
Rover 75 2000 1.8 petrol - ABS lamp on but would not connect, although read engine managment no problem.
The thing is my snapon dealer isn't much help and I am now pulling my hair out.
Has anyone got any advice they could give me? Any help would be great, thanks in advance.
Comment