Sun LS2000 Scope

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • busaf4
    Junior Member
    • Jun 2018
    • 1

    Sun LS2000 Scope

    I have a Sun LS2000 scope in working condition. I am using it for ignition issues on points ignition system.
    I can not figure out how to make the proper connections.

    It appears that channel 1 should be the secondary pickup clip, black wire to ground, and a red wire to coil side of primary. However the sun wire assembly I have does not have the red wire to coil but dies have a black wire alligator clip. The meter end of the wire assembly is red and black (common) Picture attached


    It appears that channel 2 is the trigger and uses an induction pick up on
    spark plug #1 wire. The induction pick up has red and black(common) terminal on the meter. Picture attached

    My question:

    Do I need to get a one to two adapter so I can run a red wire to channel one

    Or

    Is there a wire assembly that contains a red, black, and clamp for the secondary wire to the distributor

    Comments or suggestion greatly appreciated
    Attached Files
Working...