07 MKZ 3.5 PCM Coil Driver Problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • greasybob
    Senior Member
    • May 2008
    • 1590

    07 MKZ 3.5 PCM Coil Driver Problem

    The 07 MKZ came here to install and program a new PCM but I had to check out the coil driver problem for myself. Cylinder 5 coil control side, the PCM is holding the down at about 3 volts and only makes a slight attempt at ground it. If an open control circuit voltage would be at batt + and if a short to ground either zero volts or the PCM would still be able to pull what's still there to ground. New PCM fixed problem. It looks like new coils already installed. 2nd screen shot is a good coil firing, multi spark (2X).
    Attached Files
  • diesel71
    Senior Member
    • Feb 2008
    • 921

    #2
    Hi Bob, just so I'm on the same page, you are back probing the coil for number 5 cylinder at the coil ?

    Comment

    • greasybob
      Senior Member
      • May 2008
      • 1590

      #3
      Yes..

      Comment

      Working...