If this is your first visit, be sure to
check out the FAQ. You may have to register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
you would have to use part#EEDM5030 PRESSURE ADAPTER; IT'S ON PAGE 406 IN THE SNAP ON CATALOG 1100. YOU CAN ALSO USE PART#OTC350031 OR FLUPV350 ON PAGE 160 IN THE SNAP ON RWD 2011 CATALOG
Can the pressure sensor work with the verdict. I see in component testing
there is fuel pressure test. What do i need to get it to work
An new adapter will be required to use the Snap-on 100, 500, and 5000 PSI pressure probes with the M2 meter in conjunction with the D7 display.
I don't currently have information on when it will be available and will have to check on that.
There is a 1-500 PSI pressure/1-29"hg vacuum adapter currently available from Snap-on that can be used with the M2 scope/multimeter meter when it's set to Aux and used standalone. The part number is EEDM5030.
You can see it here:
But if you need this for the D7 display device that controls the DAQ
There is a special self powered 2 channel pressure adapter. I don’t know if it is for sale yet, (it should be soon) This adapter works well with the current pressure transducers that we have used since the original vantage PRO.
Hope this helps, Dyno Dave
Last edited by Dynodave; 02-01-2011, 08:15 PM.
Reason: closing
Comment