Purchased my new solus pro last week with new 10.2 v software,and all the adaptor leads! My first job was to read a fault on a 1998 2.8 5 series bmw,the owner had tried his local garage who could not get connected via the 16pin with his bosch scanner,hooked up using round connector under the bonnet and connected with no problems at all, identified the fault as a front right abs sensor,tested the faulty sensor and replaced,test drove with the graph mode to check output,all ok.Have never used this tool before,not even been on the course yet,"am booked in for Sept",but so far so good,the online tutorials are v good and helped me a lot.
MMS
MMS
Comment