Good morning,
Last week when I fired up my Verus Pro, the boot up screen for the Diagnostics Suite opened up, and then it froze. I let it sit like this for a few minutes. There was some colors floating at the top of the screen and so I forced a shut down with the power button. I tried starting it after a minute of shut down, but now I'm just getting a black screen. Green power light comes on with the switch, but that's all. I did hook up an outside monitor and mouse, but no luck. I have never used an outside monitor or mouse prior to this however, so I'm unsure if the Verus would send a signal out to the monitor or accept input from the mouse. I'm not a computer guy, just giving the info to any and all that might be able to help. I'm also without a Snap On dealer for the time being as mine has since retired and the new guy doesn't start for three weeks. Any help on a possible reset or what to do next is greatly appreciated.
Tom
Last week when I fired up my Verus Pro, the boot up screen for the Diagnostics Suite opened up, and then it froze. I let it sit like this for a few minutes. There was some colors floating at the top of the screen and so I forced a shut down with the power button. I tried starting it after a minute of shut down, but now I'm just getting a black screen. Green power light comes on with the switch, but that's all. I did hook up an outside monitor and mouse, but no luck. I have never used an outside monitor or mouse prior to this however, so I'm unsure if the Verus would send a signal out to the monitor or accept input from the mouse. I'm not a computer guy, just giving the info to any and all that might be able to help. I'm also without a Snap On dealer for the time being as mine has since retired and the new guy doesn't start for three weeks. Any help on a possible reset or what to do next is greatly appreciated.
Tom
Comment