Snapon Diagnostics Product Forums Diagnostic Home . Diagnostic Product Index . Customer Care        
Diagnostic SoftwareDiagnostic PlatformsAsk-a-Tech, Automotive Repair InformationTech Central
Go Back   Snapon Diagnostics Product Forums > Snap-on Diagnostic Products > Diagnostic Platforms > Lab Scope & Component Level Testing
Home Today's Posts Register Members List FAQ
Thank you for visiting Snap-on Diagnostics Product Forums.
You are currently NOT logged in to a registered account. Some functions of Snap-on Diagnostics Product Forums will not be available to you if your are not logged in as a registered member. For a limited time only, registrationto Snap-on Diagnostics Product Forums to Snap-on Diagnostics Product Forums is !! FREE !! Select the    **REGISTER NOW**    link to register for your FREE Snap-on Diagnostics Product Forums account!!

Reply
 
Thread Tools Display Modes
  #1  
Old 01-01-2020, 04:43 PM
greasybob's Avatar
greasybob greasybob is offline
Senior Member
 
Join Date: May 2008
Location: wisconsin
Posts: 1,468
greasybob You made it!  You've done a great job ofearning reputation from your peers.  You now have secret access to a new hidden forum!

Default 13 Ram 5.7 short runner valve

This one had me going for a while. I had a 13 Ram 1500 5.7 with a code P1004 , the intake short runner valve not in the desired position. The code was intermittent but it could be duplicated on a wide open throttle run most once in a while. the scanner show frequent drop outs of the position signal but this alone did not set any codes but probably not normal. Next I did a functional test of the actuator, the test passed and the scanner showed the position movement. Interesting though that with just the key on and engine off there were no drop outs in the signal. Next I Back probed the actuator signal wire. the actuator indicates it's position to the PCM by sending a pulse width signal that varies it's duty cycle time. This signal showed a very few intermittent drop outs that did not seem to match what was showing on the scanner. So replaced the actuator. No success, still was showing drop outs. Hmmmm ? Maybe the signal wire is picking up interference from somewhere or shorting to ground ? Could not find any evidence of either. Wiggle test of the harness was inconclusive too. Next step ? Clip the wire at the actuator and at the PCM and run a new one. Bingo !!! No more dropouts. Problem must be in the harness some where. There is one potential rub spot on the right rear of the engine but no damage was visible. Gonna leave the the replacement wire secured in place for now and see if the customer wants to spring for a new harness or wait and see if there is a recurrence.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -7. The time now is 06:49 AM.


Reminder: Your participation in these areas of the site is solely at your own risk. The
information is only the opinion of the poster, is no substitute for your own research,
and should not be relied upon for business critical decisions or any other purpose.
Never assume that you are anonymous and cannot be identified by your posts.
We reserve the right to discontinue any users' use of any such public forum
for any reason. Please read the Terms of Service.

Snap-on is a trademark, registered in the United States and other countries, of Snap-on Incorporated. Other marks are marks of their respective holders.
©2009 Snap-on Incorporated. All rights reserved.