I recently tried to program a used cluster (IC) for a 1999 Windstar. I built the vehicle and chose PMI for programming. It performed a setup procedure and then asked for as built data. I went to the Ford website, punched in the VIN and got all the as built data. The problem is that module 61-01 is not listed in the as built lists. There is a hyperlink that says -click here if module data required is not available below. So I clicked on it but there is nothing there about the IC programming.
So I backed out and performed the PATS key learn. So now the truck starts but there is a Traction Off light on the dash. and a U1262 is set. I suspect this is because of the unfinished programming. Does anyone know how to resolve this? My diagnostics all point to a problem with SCP data which is on pin 2 of the ALDL.
So I backed out and performed the PATS key learn. So now the truck starts but there is a Traction Off light on the dash. and a U1262 is set. I suspect this is because of the unfinished programming. Does anyone know how to resolve this? My diagnostics all point to a problem with SCP data which is on pin 2 of the ALDL.
Comment