Hi all, just got a/nother Solus, repaired it and replaced case with an intact one, and wanted to put it into ' connect to pc ' mode so I could check for a firmware update.
Scrolled down to Tools, went right, then down again and selected ' connect to pc ' and it said it would shut down, and on repowering up, it would be in ' connect to pc ' mode.
Except it comes back normally.
Anyone come across this before please ?
Scrolled down to Tools, went right, then down again and selected ' connect to pc ' and it said it would shut down, and on repowering up, it would be in ' connect to pc ' mode.
Except it comes back normally.
Anyone come across this before please ?
Comment