If this is your first visit, be sure to
check out the FAQ. You may have to register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i have a modis 10.4 update when doing readiness monitors it says test complete or not complete does that mean pass/fail or do you have to go to a different screen thanks
Complete means the monitor has run and a Pass OR Fail decision was made. Check for codes (permanent AND pending) to see if the component/system is working correctly. Mode $06 would be another option, but it's rather painful to look at on a Snap On scan tool at this point...
Comment