2014 Grand Caravan. Chasing down a u0001 code. Keyless entry & ignition switch aren't working. Just came from another shop after 8000$ insurance claim. Yuk. Time to pull the dash.
Rats
Collapse
X
-
Tags: None
-
2014 Grand Caravan. Chasing down a u0001 code. Keyless entry & ignition switch aren't working. Just came from another shop after 8000$ insurance claim. Yuk. Time to pull the dash. -
I'd be looking at the area where the accident damage was.I had a similar issue with a 14 Caravan,ended up being a cracked relay that then had corrosion in it.It was at the left front near the fuse panel.Comment
-
Here's a simple tuneup Gravy Job P0303 and P0102
Figured simple 100 k maintainance I change the plugs and clean the MAF and throttle body on a 2007 Nissan Quest 3.5. Intake plenum missing a few bolts on the back Now I'm afraid to do a compression test.Comment
-
Nissan 3.5 oil seepage in #3 sparkplug hole
After ordering a new Hitachi coil $38 and aftermarket right side valve cover $57 from Rock Auto(comes with upper tube seals and valvecover gasket, I take a look down the damn spark plug tube with my HF sewer camera and it appears the oil be leaking at the bottom of the spark plug tube where pressed onto the cylinder head, so now it is doubtful changing the valve cover with new gasket and the seals at top of the tubes will fix the oil seepage into the #3 sparkplug hole. I'ze Thinks I Beez F'N double Slepprocked with a future comeback if I don't address it now ....Wouzy Wouzy...
I don't want to pull a head to go out to a machine shop for something that might run fine a few years before oil causes a repeat Any body know if you can actually pull the tube off the head and get a proper new replacement that still maintain proper press fit?
Nissan Spark plug Tube part number for this application 11095-31U0AAttached FilesLast edited by Witsend; 03-27-2018, 05:48 PM.Comment
-
It was never in an accident. Just a prior 'ratcident' Theres a chewed up starbucks lid and a bunch of fluff way up in the dash you can see when you stand on your head. I'll check that relay down below the tipm.Comment
-
Its a U0001 in the TIPM, which is always active, and it sets a B21A1 in both door modules. As far as I know, I should be able to ignore the door module codes.Comment
-
Well, after having the complete dash out to inspect the harness. Unplugging one can bus module at a time, changing the win module, I'm at the conclusion it's gotta be the TIPM. Shopkey troubleshooting steps are retarded. Unplug the win module, then do your testing key on? Gimme a break.Comment
-
Well, after having the complete dash out to inspect the harness. Unplugging one can bus module at a time, changing the win module, I'm at the conclusion it's gotta be the TIPM. Shopkey troubleshooting steps are retarded. Unplug the win module, then do your testing key on? Gimme a break.
Reply With Quote
I did it on a 06 Chrysler Town and Country TIPM of my brother inlaw, but ran a fused wire from the relay terminal to provide a wired ground , so the van worked for years just fine with the jury rigged relay ground until he traded it in years later. Ask yourself, What would they do in Hacknsack NewJersey?Comment
-
Welp. New tipm was working until I plugged in the Hvac & radio. Guess I better order another one.Comment
Comment