Hi Group,
I had a 96 F350 7.3 L diesel in and went to the codes menu.
In the pending codes a warning popped up that the engine
should be off or the engine may stall.
I pressed "N" to exit and the Solus ran the pending code
routine, stalled the engine, and set a P0606 - processor
fault.
I exited the menu and then went back to the pending codes with the engine off. I pressed the "N" to exit and it went into the pending code routine.
Has anybody else run into this where you can not exit from the pending codes?
Thanks,
dave
I had a 96 F350 7.3 L diesel in and went to the codes menu.
In the pending codes a warning popped up that the engine
should be off or the engine may stall.
I pressed "N" to exit and the Solus ran the pending code
routine, stalled the engine, and set a P0606 - processor
fault.
I exited the menu and then went back to the pending codes with the engine off. I pressed the "N" to exit and it went into the pending code routine.
Has anybody else run into this where you can not exit from the pending codes?
Thanks,
dave