There is not a way to pull pending codes on a Toyota Echo vin #JTDBT1233Y0056913. I have one code and in the data list it says there is a pending code but no way to see the pending code. I even tried the legacy software as well. Used to be able to do it only in generic obdII but that is no longer on asian scanner......
No pending codes???
Collapse
X
-
Tags: None
-
-
I have run into this before. The only way I got the pending code was witth a factory scan tool. Have you tried global obd 2, mode 6. codes set during last drive cycle?Comment
-
Did not try that.....just the generic obdII in the legacy software....car is gone now but if I run ionto it again, I'll definitrly give it a shot....Thanks!MasterWrenchComment
-
Comment
-
Pending codes.
There are actually three places to get pending codes. If you select Asian legacy you will find Generic at the bottom of the list. I like this one because you have some mode6 and some mode9 information as well. The best place however is in Global EOB. As you probably know, the Snapon platform offers all ten testing modes. 1-9 and 9B. While you are there check out mode8, test 01. For the carlines that support it you can seal the evap system for testing.
If you are on a Ford try mode6, test $53. This misfire information could heal your life on a 5.4 with no codes and misfires.
Best wishes,
CoyoteComment
-
There are actually three places to get pending codes. If you select Asian legacy you will find Generic at the bottom of the list. I like this one because you have some mode6 and some mode9 information as well. The best place however is in Global EOB. As you probably know, the Snapon platform offers all ten testing modes. 1-9 and 9B. While you are there check out mode8, test 01. For the carlines that support it you can seal the evap system for testing.
If you are on a Ford try mode6, test $53. This misfire information could heal your life on a 5.4 with no codes and misfires.
Best wishes,
Coyote
mode 6 data should be deciphered and available on future MODIS updates....just a suggestionMasterWrenchComment
Comment