This was Bob's comment in the first post. "I put a screen shot in here too of a normal coil firing with current ramp,"
That wasn't the bad plug in the picture where the first CURRENT RAMP was.
The second picture of a current ramp was the bad plug. The amplitude wasn't as high on the bad plug.
The current changes with the bad plug. That's all I was pointing out.
Without the "graph" selected on the scope screen and looking at the amperage on the left pink numbers, it isn't obvious.
If Bob could pull up the movies and put "graph" display on, then drag the cursor across to where the current peaks, then it would show in the "min" "max" numbers at the bottom.
Rich put up a pretty good description of the "multi-strike" system.
That wasn't the bad plug in the picture where the first CURRENT RAMP was.
The second picture of a current ramp was the bad plug. The amplitude wasn't as high on the bad plug.
The current changes with the bad plug. That's all I was pointing out.
Without the "graph" selected on the scope screen and looking at the amperage on the left pink numbers, it isn't obvious.
If Bob could pull up the movies and put "graph" display on, then drag the cursor across to where the current peaks, then it would show in the "min" "max" numbers at the bottom.
Rich put up a pretty good description of the "multi-strike" system.
Comment