locating cylinder misfire with solus pro software version 10.2

[aferris1212]

I am working on a 2005 ford expedtion with misfire underload the scanner is accumulating misfires in the datalist portion but doesn't give cylinder location for misfire how can i get the scan tool to show me misfire 1-8 thanks austin

[Joe Rappa]

In the Functional Test Menu
Cylinder Contribution Test

[Orevin]

In the Functional Test Menu
Cylinder Contribution Test

Hi Joe,

Was the CCT available for CAN equipped Ford in 10.2 ...?

I am working on a 2005 ford expedtion with misfire underload the scanner is accumulating misfires in the datalist portion but doesn't give cylinder location for misfire how can i get the scan tool to show me misfire 1-8 thanks austin

You might have to upgrade your Solus Pro to be able to use the CCT.

If you haven't reset KAM yet, you could find the information in Mode$06 test results, under Generic Functions.

[Joe Rappa]

You're right orevin. 10.2 only had coverage through '94.

Mode 6 is going to be the easiest way to figure it out without that test.

Joe