Originally Posted by Red89notch
I just got the thermal imager today.
I was able to take 1 picture. I go to navigate to the pictures and I only have 1 saved picture.
Instructions say to just click the trigger, I do that but it doesn't save any pictures.
This one was opened and used to demo it, so I was wondering if there was a setting that I can't find that disables picture saving
Did you buy this new or used? Make sure the micro usd is in the top slot. Also verify the micro usd is not full, you can do this by plugging in the device to a pc and checking the drive status in properties or pop the card out of the top slot and install into the computer with a proper adaptor. For additional support contact diagnostic customer care at 800-424-7226