I realize this has been posted before here: http://productforum.autorepairdata.c...ead.php?t=8966
But, I tried the answers there and had no luck. Figured I'd ask and see if anyone has any ideas.
when launching ShopStream I get the message:
Hardware Initialization Warning
The application has detected that the hardware is not fully initialized.
Please re-launch the application.
If the problem persists, please reboot your device and then re-launch the application.
The application will now exit.
So far, not much luck with Snap-On support, but I'll keep waiting to hear back from them. I ran SNORE.exe to reinstall. I installed the cp2103 usb to uart bridge driver, even though, at the moment there are no missing drivers for any device in device manager. From this page:
I ran the USBExpress_Reset_V2_0.exe and the HardwareInit_V_1_4.exe and had no luck. I've tried a full reinstall.
But, I tried the answers there and had no luck. Figured I'd ask and see if anyone has any ideas.
when launching ShopStream I get the message:
Hardware Initialization Warning
The application has detected that the hardware is not fully initialized.
Please re-launch the application.
If the problem persists, please reboot your device and then re-launch the application.
The application will now exit.
So far, not much luck with Snap-On support, but I'll keep waiting to hear back from them. I ran SNORE.exe to reinstall. I installed the cp2103 usb to uart bridge driver, even though, at the moment there are no missing drivers for any device in device manager. From this page:
I ran the USBExpress_Reset_V2_0.exe and the HardwareInit_V_1_4.exe and had no luck. I've tried a full reinstall.
Comment