Recently had a 2018 GMC Terrain in Vin 3GKALPEV9JL255716 in with ABS,Trac, Stability, Check engine lights on, Dud a full system scan, Had various system U codes, mostly U0073 can"A" code, rt rr wheel speed sensor missing code C0050, C025F master cylinder calibration not learned, U0422 missing parking assist data, and all other various U codes for missing communication with various modules. Scanned wss and was missing rear speed signal, was able to swap side to side, still right side dead. Next step was look at EBCM, but had a new one installed with correct calibration. Decided to try GDS 2 and it had all different codes, mainly U0077, which is HS Can 2 off line. This is different circuits than Can A which is terminal 6 and 14 in DLC. This is terminals 12 and 13 in DLC.Ended up be bad x402 connector in rt rr of vehicle, had pins for Can 2 pushed out. Repaired wiring, cleared codes, rechecked. Still had code C0025f in ABS. There was a setup procedure in SPS to do this. Performed EBCM setup procedure, rear brake caliper calibration , all okay now. Verus showed U0073 for Can A problem. GDS 2 had code U0077, CAN 2 problem. completely different diagnostic tree. Probably didn't need EBCM replaced at all.
Wrong codes displayed
Collapse
X
-
-
John
Scroll down to "Manage attachments"
Capture2.JPG
A new menu will open up asking you to select the files, select them the click upload, then close that menu.Click on the Paperclip and it will allow you to attach your uploaded files to the post.
Capture.JPGComment
-
Comment
-
-
Thanks Steve for helping with the attachments.Comment
-
-
Comment
-
Thank you. I'm going to trade my Solus Edge For the D10. Which I'm already paying for. But I'm trading it with the latest version. Thanks!Comment
-
Thank you steve! I tried it out and the thing boots in 2 seconds! None of the other tools right now boot that fast. Can't wait. My distributor just told me the latest version is out. But I see no updates on ShopStream Connect.Comment
Comment