ok, next difficult question.
My new to me Solus Ultra has 19.2 software in it. It has a cracked screen but has been working just fine using the buttons. I'm working my way through the manual and it talks about touchscreen calibration. I was excited, didn't even know it had that. I started trying to calibrate it even though its cracked. Well since its cracked it won't recognize anything but the top left corner. I can keep tapping the top left corner and it will eventually recognize each corner and let me out of the calibration screen. After that the unit works again. Until I power off then it boots right back to the touch screen calibration.
Any ideas how to stop that or where besides snap on to get a touch screen replaced? They want more than I paid for the tool.
Thanks again
Bill
My new to me Solus Ultra has 19.2 software in it. It has a cracked screen but has been working just fine using the buttons. I'm working my way through the manual and it talks about touchscreen calibration. I was excited, didn't even know it had that. I started trying to calibrate it even though its cracked. Well since its cracked it won't recognize anything but the top left corner. I can keep tapping the top left corner and it will eventually recognize each corner and let me out of the calibration screen. After that the unit works again. Until I power off then it boots right back to the touch screen calibration.
Any ideas how to stop that or where besides snap on to get a touch screen replaced? They want more than I paid for the tool.
Thanks again
Bill
Comment