I am relatively new to J2534 programming as I have most of my experience directly with the DRB3 on pre CAN Chrysler products with NGC controllers. I have access to most of the calibration files that I need from an ISIS/ITIL disk but there are a few that I need but are not available for download. I am hoping that the solution lies in the spare PCMs that I have that are already programmed with the calibrations that I am trying to get my hands on... My question is, is there a way for me to essentially read the calibration from the PCM/ECU onto my PC? I have done a lot of searching but cannot find the answer to this.