Tweet
Programmable Module Installation
Hey Ya'll,
Do any of the SO scan tools offer Ford PMI (Inhale / Exhale Option) without using the J2534 and buying a subscription?
MATCO scanners can pull the data from the old module and once the replacement module is installed, can upload the data from the original module. This is part of their software package and not an add-on. This is NOT programming in the sense that say, a new PCM might require, but rather an instrument cluster. This translates into less $ spent by the customer. Seems SO should be leading the way!
I have a full function Zeuss and cannot find PMI transfer function within the platform. I can program Key FOB's, Transmitters, PATS access & the like but no PMI (inhale / exhale) option if I need to grab old cluster data, I have to use the J2534 with a Ford Download.
See note:
Programmable Module Installation (PMI)
PMI is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started. If this data cannot be retrieved from the module being replaced, the scan tool may prompt for As-Built data entry or display a list of parameter values that need to be manually selected. Some modules are reprogrammed during PMI when a strategy/calibration update is available. To carry out PMI , refer to Programmable Module Installation (PMI) in this section.
NOTE:
It is important that the scan tool identifies the vehicle and obtains configuration data prior to removing any modules. The new module must be able to communicate with the scan tool in order to carry out PMI .
Thanks!
Do any of the SO scan tools offer Ford PMI (Inhale / Exhale Option) without using the J2534 and buying a subscription?
MATCO scanners can pull the data from the old module and once the replacement module is installed, can upload the data from the original module. This is part of their software package and not an add-on. This is NOT programming in the sense that say, a new PCM might require, but rather an instrument cluster. This translates into less $ spent by the customer. Seems SO should be leading the way!
I have a full function Zeuss and cannot find PMI transfer function within the platform. I can program Key FOB's, Transmitters, PATS access & the like but no PMI (inhale / exhale) option if I need to grab old cluster data, I have to use the J2534 with a Ford Download.
See note:
Programmable Module Installation (PMI)
PMI is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started. If this data cannot be retrieved from the module being replaced, the scan tool may prompt for As-Built data entry or display a list of parameter values that need to be manually selected. Some modules are reprogrammed during PMI when a strategy/calibration update is available. To carry out PMI , refer to Programmable Module Installation (PMI) in this section.
NOTE:
It is important that the scan tool identifies the vehicle and obtains configuration data prior to removing any modules. The new module must be able to communicate with the scan tool in order to carry out PMI .
Thanks!
Comment