Want to fabricate a couple Counselor 2 adapters

[Witsend]

I first want to make a #1 trigger adapter that is not as bulky as the #1 spark plug wire adapter that I could get into tighter areas and go around the primary pigtail of the #1coil or the #1 fuel injector for #1 trigger or rpm reference.
Next I would like to fabricate an adapter to make something work off the the auxiliary cable to use with a pressure transducer.
My first step would be getting the adapter side thread on barrel connector parts to fit the Counselor 2 cable ends.
I Found those parts are available through Digikey.

terminal half of 16 pin barrel style connector AMP 206036-3
terminals 66593
wire side half of barrel connector 206070-8

http://www.digikey.com/product-detai...1GqhoCizTw_wcB


terminal side half of #1 sparkplug trigger reference adapter barrel connector AMP 206705-2
terminal 66099-3
wire side half of #1 trigger barrel connector AMP 206966-7 or 9

http://www.digikey.com/product-detai...Dj2RoCfNzw_wcB

[Witsend]

Pressure transducer

i think I could still get by using Home made pressure transducer set up similar to what this guy created, and try using with my Counselor 2 set to lab scope and use the existing white lead and the auxiliary lead without doing anything special, unfortunately my Counselor 2 can't sync the secondary ignition pattern with the in cylinder pressure transducer. The lab scope and secondary ignition are accessed in different menu.I haven't seen video or found anything yet about a pressure transducer being used off a counselor 2.
Anyone seriously considering getting L1and L2 certs should consider in cylinder testing and subscription to Scanner D.