The wheels on the bus are spinning and I'm throwing so under it.
I had my origanal modis for a total of six years,the first six months was fine then I got an error message that said system overtemp unit shutting down.that meant it could not be turned back on period,$400.00 dollars and four and a half years later and with the help of laywers they finally swapped it out.I had paid it off and only used it for the first six months and so took it to that extreme,WHY?
Next I traded for a verus it kept locking up but so did swap it out,now it is just slow as dirt like everyone elses,for ten grand so should do better by us"were the reason that they are a fortune500 company and not bankrupt.
Finally I got my epiq in,powerhouse bolts were loose so I tightened them and then the lid would not shut,dealer tells me "just loosen them back up".
Three different paint flaws,and a drawer that makes a very loud popping noise when you open it.I am completely fed up with this **** where is the quality control,why do they not care about us when I spend 10 grand on a scanner,15 grand on a toolbox not to mention the thousands on other tools it should be perfect when I recieve it I should not have to log book hours complaining about it or fighting with it to get it to work.
Basically snapon what I am saying is if u as a company would like to stay in business and out of the negative you need to stop treating us like this.
"we techs get paid on flat rate extremely slow scanners hender us from making money but it dosent seem to stop you from taking ours every week".
I had my origanal modis for a total of six years,the first six months was fine then I got an error message that said system overtemp unit shutting down.that meant it could not be turned back on period,$400.00 dollars and four and a half years later and with the help of laywers they finally swapped it out.I had paid it off and only used it for the first six months and so took it to that extreme,WHY?
Next I traded for a verus it kept locking up but so did swap it out,now it is just slow as dirt like everyone elses,for ten grand so should do better by us"were the reason that they are a fortune500 company and not bankrupt.
Finally I got my epiq in,powerhouse bolts were loose so I tightened them and then the lid would not shut,dealer tells me "just loosen them back up".
Three different paint flaws,and a drawer that makes a very loud popping noise when you open it.I am completely fed up with this **** where is the quality control,why do they not care about us when I spend 10 grand on a scanner,15 grand on a toolbox not to mention the thousands on other tools it should be perfect when I recieve it I should not have to log book hours complaining about it or fighting with it to get it to work.
Basically snapon what I am saying is if u as a company would like to stay in business and out of the negative you need to stop treating us like this.
"we techs get paid on flat rate extremely slow scanners hender us from making money but it dosent seem to stop you from taking ours every week".
. Your as good as the last dollar you spend
Comment