Hello Group.
Has anyone had a problem getting the ohm meter to zero. Seems mine has a problem now. I really have not used the ohm meter function much since its so slow and does not graph at all. I usually use the Vantage or VP. I believe this problem has started since the 9.2 update or the service release for it. I tried another lead set and same problem. After zeroing the meter will read between 90 and 120 ohms with the leads connected together.
On another note I noticed that the Vantage Pro now supports the graphing feature in ohms. Why doesn't the Verus. I found this a huge asset when trying to find intermittent shorts or opens in wires such as a speed sensor circuit. I would connect to the suspect sensor circuit at the processor reading the entire circuit resistance in a graph mode and then simply excercise the wires while monitoring the graph. We need this capability on the Verus too IMHO.
Has anyone had a problem getting the ohm meter to zero. Seems mine has a problem now. I really have not used the ohm meter function much since its so slow and does not graph at all. I usually use the Vantage or VP. I believe this problem has started since the 9.2 update or the service release for it. I tried another lead set and same problem. After zeroing the meter will read between 90 and 120 ohms with the leads connected together.
On another note I noticed that the Vantage Pro now supports the graphing feature in ohms. Why doesn't the Verus. I found this a huge asset when trying to find intermittent shorts or opens in wires such as a speed sensor circuit. I would connect to the suspect sensor circuit at the processor reading the entire circuit resistance in a graph mode and then simply excercise the wires while monitoring the graph. We need this capability on the Verus too IMHO.
Comment